It's not laser cut. I used a MakerBot Replicator 2. It was actually quite easy to print. I designed it roughly two years ago after browsing thingiverse and getting bad print results with the larger stands. The smaller single-piece stands were too flimsy/unstable. I also wanted the stand to be just big enough to fit a Lenovo docking station under it.
knolan|8 years ago
It would be difficult, and inadvisable to print something this large on a regular 3D printer.
Thingyverse is literally full of designs like this and often much better.
https://www.thingiverse.com/search/page:1?q=Laptop+stand&sa=...
discreditable|8 years ago
discreditable|8 years ago