Probably, but I would think you'd need to use a paste stencil to raise the PCB contacts evenly above the solder mask layer since it's not quite flush, or just get the board pre-tinned.
Didn't think of that one, that could definitely be an issue. I suppose if you're DIYing them you could probably just hand tin them, at least with flex PCBs.
Or, if you're doing OneWire based modules, just only use 3 contacts so evenness is less important.
eternityforest|2 years ago
Or, if you're doing OneWire based modules, just only use 3 contacts so evenness is less important.