[neilo40]

Although it looks like BGA, it actually uses a QFN package where all the contacts are accessible at the edge. With a little practice they are relatively easy to hand solder (I've done many, not just rp2040)

[dvdkon]

QFN packages are very nice to hand-solder in my experience, considering the pitch. Better than the bridge-prone pins of QFP. The bottom pads do need some preparation, but you don't need hot air or reflow.

[kragen]

i admit to being intimidated by qfns still. any tips for hand-soldering them successfully?

[dfox]

Kind of cheating trick for the QFN substrate pad is to put a grid of somewhat higher diameter vias in there and solder the pad from the other side of the board through these vias. Another approach is to just ignore the substrate pad altogether (in many devices it should not be connected to anything anyway and has no real thermal management purpose).