[milianw]

perf is easily available through yocto and buildroot (and probably other embedded linux image builders). hotspot can be downloaded as an appimage. It should not take 30-60min to set this up, but granted, learning the tools the first time always has some cost.

Furthermore, note how your reasoning is quite different from what the website you linked to says - it basically says "there are no good tools" (which is untrue) whereas you are saying "manual GDB sampling might be good enough and is easier to setup than a good tool" (which is certainly true).

[kragen]

the vast majority of embedded cpus cannot run yocto or indeed linux, even the arms

but they all support gdb

[milianw]

True, that's another good point. But again, this reasoning is very different to the one from the linked article and website - if you have oprofile or valgrind's cachegrind available, you clearly could get perf setup instead.

I'm not debating that manual GDB sampling has its place and value. I'm debating that perf is "lying" or that it's impossible to get hold of off-CPU samples, or profiling of multithreaded code in general.

[kragen]

(well, not all)