[open_erv2]

The step files are also there, which is the best common denominator for CAD files. Again, it's open source for the purpose of maintenance and repair, not cloning, and frankly earlier on I did make it more community oriented and nobody ever contributed even a little bit, so I just gave up on that idea.

The most likely scenario for longer term is that people may submit minor patches or suggestions, which I roll into the hardware or firmware. In reality, hardware is not like software. You can't make changes easily. Some wizards may take it upon themselves to spruce up the firmware with fancy features and release something, which anyone is free to do. There would then be multiple compatible versions of the firmware, one which I curate for reliability with minimal features, and others which others can provide. Same as for 3d printer firmware.

  The firmware is Micropython, which is extremely easy to understand and modify.