[alienchow]

Hey actually I didn't know! It's my very first time dealing with fibre networking so I just maxed out the supposed durability specs. I figured I'd rather go overkill than regret not having done so. Ironic I know.

Unfortunately I can't easily dig the cable out and bury it again in this case. I'll have to figure out how to pull a new cable using the existing cable through the PVC conduits as the cable shares a larger conduit with multiple other fibre and Ethernet cables. The whole project was orchestrated remotely in a different timezone with me giving the electricians instructions over WhatsApp photos and audio recordings, so that limited what I could realistically control onsite back then. Often the contractors would proceed with a do first ask questions later approach while I was still asleep. The networking project was holding up the entire home renovation so everything was learnt and planned in a short amount of time.

AFAIK fibre splicing and terminating tools are very expensive. Do point me in the right direction for the $50 tools and I could go get some and DIY.

[Sesse__]

> AFAIK fibre splicing and terminating tools are very expensive.

They're more like $600 expensive than $6000 expensive these days. For very low budget, you could go with a mechanical (aerobic) splice; it's more loss, less robust and takes up more space, but doesn't require a fusion splicer.

[adinisom]

If you want to pull another cable:

- secure a string to the old cable

- pull the cable out the other end, pulling the string through

- secure the string to the new cable

- pull the string out the other end, pulling the new cable into position

[EvanAnderson]

Pull a string alongside the new cable, too, and tie it off on both ends. Always leave a pull string in the conduit.

[alexfoo]

You forgot to also tie another piece of string to the new cable so that you pull the new cable AND this other bit of string through.

This gives you a piece of string in the conduit run to be able to pull through the next thing days/weeks/years later.

[jaeckel]

> [...] a string [...]

Does someone have a recommendation for a specific material the string should be made of?

[fried-gluttony]

Excuse me to hijack this comment adinisom.

I wanted to reach you regarding your comment here: https://news.ycombinator.com/item?id=44547866 Would you be willing to maybe elaborate on the problems caused - I've planned to adopt Miro Sameks for an application? DM me via my about me, if interested. Would be very thankful.