[lizknope]

The other alternative is that you sprinkle spare gates around the chip. If the chip is 10mm x 10mm then every 100 microns you put a group of cells that just have their inputs tied to 0 and the outputs go nowhere. You put in a good mix of flip flops, and combinational logic cells. Then when you need to do a metal ECO the RTL team says "We need 2 AND gates, 1 OR gate, 1 mux, and they are connected to these 5 cells." So you highlight those 5 cells and find the closest spare logic group and use those.

The ECOFILLER gate array style cells are easier to use.

Then during the DRC check process in Calibre we run a check to make sure that the base layers stayed the same and only the metal layers changed. Since we have 18 metal layers in a leading edge node hopefully only metal layers 1 to 3 changed for the metal ECO so you only have to pay to make new versions of that.

A full mask set in 3nm can be over $30 million. Just a new set of metal masks is around $20 million.

A full mask run takes about 4 months in the fab. Normally you tell the fab to keep a few wafers after the base layers and don't manufacture the metal layers. Then when you do a metal respin they get those out of storage and save a month.

[random_duck]

So you want to sprinkle the faster cell groups around, but the ecofiller gates are more flexible since they are everywhere by default ?

> Normally you tell the fab to keep a few wafers after the base layers and don't manufacture the metal layers.

Oh, I had no idea that was a thing.

[lizknope]

I've been doing this for 30 years.

Blocks are never 100% full. If it was then you would never be able to route the design. High utilization may be 70% but if a block has tons of IO then I've worked on blocks that are only 25% utilized. For various manufacturing and yield purposes the empty spaces need filler cells.

Sometimes we put in decoupling cap cells. But the ecofiller cells go in everywhere else.

About 25 years ago we were using spare gates that we had preplaced on the die.

About 5 years ago we started using spare gates preplaced and ALSO the ecofiller cells. The reason I was told was to save money because the ecofiller cells require some other mask layer to change. I think that was in the $500K range but it's still money.

In general I hate doing ECO's with the preplaced spare gates as it is manual and time consuming to find the best cells to use.