(no title)
atoav | 9 days ago
Heat for removal works but is always like defusing a inextinguishable bomb and takes much more time than it should. I also have rarely seen a design where the glue was really necessary for the design. Basically they could just have put the battery in without glue and it would have worked just as fine.
Maybe companies really need that kind of regulation to so the common sense right thing.
There are excemptions in cases where it is really technically needed as far as I can tell (medical, water-tightness for safety reasons, data integrity needed so battery can't be removed). I hope they are not too lax with those.
blell|9 days ago
mschuster91|9 days ago
The problem is that you need heat to open up the device itself (all that is between the battery and the hot air gun is about 1mm of glass), followed by a bath in isopropanol and lots and lots of twaddling around with tweezers and spatulas to get the old glue residue removed from both the display and the case (risking damaging either in the process), followed by really annoying meticulous work to place a new glue sheet exactly onto the case (or display) to make sure it fits again. Oh and you always risk cracking the display while removing it.
atoav|9 days ago
Try it with a modern Fairphone for example. I had one for years and not a single time the back lid fell off or the battery disconnected. I had a couple of batteries die in phones tho. General point: If you argue with people who have more experience on an issue than you, bring the receipts and red-team your own statement before you make it. Everything else doesn't really shine a good light on you.
lozenge|9 days ago
omnimus|9 days ago